Page 544 - Cornwell Product Catalog
P. 544

Truck Hub Seal Installer Kit
Fits the most popular
sizes for class 7 and class
8 over the road trucks and trailers and some medium duty trucks. Comes with
(5) drivers and handle extension for extra reach for driving seals on hubs with deep brake drums without removing the drums.
LS61700 LS61710 LS61720 LS61730 LS61740 LS59530 LS59540
Hub GrapplerTM
The complete solution for servicing wheel hubs and bearings on the vehicle without removing
4-13/16" Driver 6-5/16" Driver 5-31/32" Driver 5-11/16" Driver 6" Driver Handle Extension Handle
Adjustable Bearing Seal Driver
All in one design eliminates the need
for a driver and different size adapters.
Locking screw holds the adjustable
jaws in place for one hand use. Durable
sturdy aluminum construction,
equipped with a steel capped striker
shaft handle. 3-stepped jaws quickly adjust to accommodate bearing races and seals from 0.708” - 3.543” (18mm – 90mm)
Bearing Packer
Quickly flushes out old grease and repacks bearings with less mess. Works on bearings
up to 3-1/2" O.D. The grease stays in the tool cavity, not on your hands. To pack a bearing: place the bearing on the piston, press down
on the cap until the old grease is forced out
and the new grease shows on top of the bearing.
Dodge Wheel & Hub Remover Tool
Designed to remove the front hubs
of 3/4-ton (2500 series) and 1-ton
(3500 series) Dodge pick-up trucks.
Cuts the flat rate for changing
U-joints, front differential service,
ball joints, and any front hub service. On average it takes 3.4 hours to complete both sides. This tool will cut that time down to one hour.
Hub Removal Kit for Dodge
Separates the frozen
hub assembly from the
steering knuckle on Dodge
vehicles. Tool drives
against loosened retaining
bolts to separate assembly.
Prevents damage to the
knuckle and complete hub
assembly. Tool drives on
the bolt flange, so the head of the retaining bolt is not destroyed.
                       the steering
components or
knuckle. This eliminates
unnecessary alignments or
the use of a shop press, cutting service time dramatically. The Hub GrapplerTM Puller is specifically designed to apply maximum force with minimal effort from an impact gun to also minimize service time. The jaws are designed and sized to properly fit hub applications and can be quickly located on the puller bar without the use of fasteners. The 3/4” custom drive screw, coupled with the special equalizer washer, provides smooth operation while the proprietary heat treating extends its life 5-10 times longer than similar designs. Adapters provide application coverage up to 2009 model year. Includes tie rod/ ball joint tool and Ford axle installers. The Hub GrapplerTM Application Guide is the most comprehensive hub and bearing service guide on the market, developed to be the first tool used in the kit to provide quick reference to the other tools in the kit required to do the job, eliminating guesswork and saving time.
LS39250 LS39300
Hub Remover Tool
Front Hub & Knuckle Separator
       542 1-800-321-8356

   542   543   544   545   546