Page 457 - Cornwell Product Catalog
P. 457

Battery Terminal & Wiper Arm Puller
Dual purpose puller.
Removes stuck battery
terminals. Tighten
knurled cone to force
jaws under the cable
clamp. Turn center
screw to lift clamp off
terminal. Also removes
bolted on windshield
wiper arms that fit over a tapered spline. Puller screw pad is designed to fit the top of the spline post for easy pulling.
ECS520 Side Battery Lifter
Lifts side terminal
and top post terminal
batteries, including
group 65 batteries.
Lightweight but strong.
All steel construction.
Notched cross-member
to prevent slippage.
Adjusts to pick up
batteries 4-1/2” to 7-1/2”
wide. Pads are adhered with super strong adhesive. Non-slip vinyl covered insulated handle for firm, comfortable handhold.
Battery Carrier
Lift and carry
batteries safely.
Sturdy steel
jaws securely
hold batteries.
handle turns lifting
power into battery
gripping pressure.
Form-fitting handle provides a solid gripping surface. Carrier works on nearly all batteries, from motorcycles to boats. Saw- tooth jaw tips provide no-slip battery gripping power. Carrier grips the battery just below the top lip for good balance. A heavy-duty tool that is built to last. Opens up to 10”.
5-3/4" Battery Wrench
Designed for removal of 5/16” GM side terminal battery bolts. Reaches most battery side terminals. Nickel-chrome plated for quality and appearance. Vinyl grip insulated handles. Reversing lever for accessibility. Critical parts are heat-treated to ensure safety and long service. Works on all GM 1994 to present vehicles and on the following cars, but not limited to: W-Body: Buick Regal, Chevrolet Lumina, Pontiac Grand Am and Grand Prix; Oldsmobile Cutlass.
SLC15600 Battery/Welding Cable Crimper
Convenient 14mm bolt
head and 16mm casting
hex size is compact
and heat treated for
durability. Crimps up to 0 AWG cable terminal ends. Designed to service battery cables while still attached to the vehicle, using a common wrench and ratchet. No hammer required.
      Use each tool properly. See page 688 for safety warnings. 455
Slim-line Style Battery Cable Cutter
Prepares battery cable for terminals. Works well on bundled small wires. Cuts soft cable cleanly, with no distortion. Thin, sharp blades for firm hold. Ground blade guide to minimize deflection. Standard finish is conversion coat black oxide. Long handles with broad vinyl cushion red grips. Positive fastener (jamb not on joint) to maintain even pressure on ground inside surface of blades. NOT FOR USE ON STEEL WIRES - cutters bear this caution! Overall length: 7-1/2”; Handle length: 6”; Width: 1-1/4”; Thickness: 3/4”. Weight: 9 oz.; Capacity: 3/0 cable.

   455   456   457   458   459