Page 19 - September 2020 Monthly Flyer
P. 19

 UNDERCARRIAGE & WHEEL
 Spill-FreeTM Funnel
$49.95 $58.25 LS24780
Eliminates trapped air pockets and enables unattended filling of the cooling system. Clear funnel allows a quick visual check. Five colored adapters and five caps to fit most vehicles. Straight extension and two 45° elbows for angled and hard-to-reach
applications. Includes lid to keep contaminants out and store the adapters
when not in use.
 Quickflow Pump
21MM Double Offset Caster Wrench
 $139.95 $177.95
Uses cordless drill to
pump most fluid types.
High strength fiberglass
reinforced nylon housing.
Extreme chemical resistance
Universal adaptor with rubber mounting strap. Runs up to 1,500 RPM. Quick connect hose couplers. 1/4” hex to 3/8” drive drill adaptor included.
Eight Gallon Oil Lift Drain
$169.95 $225.50 LS11102
Large 15” funnel with strainer. Wide working range 36-1/2” to 74”. Large handle and big pour spout with threaded cap. Low center of gravity. Four 2-1/2” ball bearing swivel wheels. Translucent eight gallon jug and reinforced base.
Oil Funnel
$52.95 $65.95 Helps eliminate oil spills
when refilling crankcases.
The 1.6 qt. translucent
funnel comes with (7) different color-coded adapters and a 45° elbow. The adapters fit crankcases securely. Use spout only as a standard funnel.
$39.95 $52.75
PBT7
LS41340
LS1934
1", 2"
and 3/4"
forked
adjustable
pry bars, Hex Shank: 5/8". Overall length: 24"
Axle Popper Kit
$62.95 SM71410
Half shafts are sometimes difficult to break loose with a pry bar. The Axle Popper kit is quick and sure every time and will save time.
Front End Service Set
$179.95 $204.95 OWC6295
Allows for easy removal of the most popular types of Pitman arms, tie rods, and ball joints. Press-type ball joint separator allows for ball joint removal without the damage to boots and other parts that fork-type removers may cause.
5 Piece Stepped Pickle Fork Kit
$134.95 $157.25 LS41440
Step design on the forks keeps the tool from bouncing back when separating ball joints, steering dampeners, tie rods, Pitman arms and other applications. Includes five forks: 11/16”, 15/16”, 1-1/8”, 1-7/16” and 1-5/8”
Toyota Front Hub Nut Socket
$69.95 $78.95 HR977
Designed to fit Toyota front hub
lock nuts on 2007 and up 2WD
4Runner and Tundra (2008-2014
Sequoia) model. Allows easy
removal and installation on front
hub locknut without damage to the nut. 8-Pin design, with 3/4” female drive. Comparable to Toyota factory tool #09318-12010-8Pin and 09602-60010.
Multipurpose Bearing & Pulley Puller Set
$189.95 OWC4534
Set includes drop-forged
components, which can be used in a variety of combinations. Spread: 3” to 5”, Reach: 1” to 2-1/4”
Blind Hole Bearing Puller Set
$179.95 $209.95 HR29
Designed for removing
recessed bearings.
Set includes a 2-1/2”
lb. slide hammer with
T-Handle and four collets,
for a wide range of
applications. Ideal for
removing pilot bearings.
Collet sizes: 3/8” to 1/2” (10MM - 14MM), 9/16” to 11/16” (15MM - 19MM), 5/8” to 1” (18MM - 25MM), and 1” to 1-1/4” (25MM - 32MM).
12 Piece Multi-Application Oil Funnel Kit
$89.95 $109.2
Helps eliminate
oil spills
when refilling
crankcases. 1.6
qt. translucent
funnel includes
twelve different color-coded crankcase adapters and a 45°elbow. Use spout only as a standard funnel.
Truck Ball Joint Master Kit
$995.95 $1,189.95
This 55+ piece kit covers press- in ball joints on
OW6539
1196
.
The 14-1/2” 21MM
wrench can be used
from bottom side of
vehicle to move hard-
to-reach and often
rusty OEM cams on 1999 and newer GM vehicles with coil spring front suspensions.
Inner Tie Rod Tool
$94.95 $112.15 LS45750
Works on inner tie rods with
inaccessible wrench flats.
Tool utilizes six crowfeet,
sizes 1-3/16”, 1-1/4”, 1-5/16”,
1-7/16”, 1-1/2” and 33.6MM to engage the wrench flats.
3 Piece Forked Adjustable Pry
$134.95 $157.95 Includes:
   Bar Kit
CTGFPKIT
  2
  5 LS19612
       the following Truck/Van/SUV applications: Toyota, Hyundai, Kia, Infiniti, Isuzu, Nissan, Chrysler, Dodge, Jeep, Plymouth, Mitsubishi, Ford, Lincoln, Mercury, Mazda, Chevrolet, Buick, Oldsmobile, Pontiac, Cadillac, GMC and Hummer.
NOTE: All items shown in this flyer are limited in quantities and subject to availability. Please also note that the printed color may differ from the actual color due to variations in the printing process. Cornwell®, the Ironman Logo, The Choice of Professionals® and bluePOWER® are registered trademarks of the Cornwell® Quality Tools Company.
SEPTEMBER 2020 19
eliminates
TRAPPED AIR POCKETS
  FEATURE
  
   17   18   19   20   21